Starting the write operation 1. Press the WRITE Mode key.
Specifying a program name
You can give the program to be saved a name consisting of up to 12 characters If you
don't change the program name, proceed to step 7.
2. Press the “A” double function edit control [RENAME].
Program number
Program name - max 12 characters
List of available characters
3. Rotate the "C" double function edit control [SEL] to select the characters of
the program name.
Press the “D” (-) or the "E" (+) double function edit control to single-step through the list of
available characters. You may also select the characters by pressing the UP/DOWN
keys.
Pressing the “P” double function edit control [U/L] changes a character to uppercase or
lowercase.
4. After selecting a character, press the "B" double function edit control "►" to
move the cursor forward within the name field.
Press the "A" double function edit control “◄” to move the cursor backward within the
name field.
5. Repeat steps 3 and 4 to specify all of the characters of the program name.
To Next Page
Loading...
Need help?
General
