2/Volume Pedal Placement
The output volume can be controlled with a volume pedal connected to the VOL.
PEDAL input on the rear panel.
Follow the procedure below to set the volume pedal placement or position in an
effect Chain.
1. While EDIT SELECT is shown on the display, press the PAGE+ key twice.
The Program Utility menu is displayed.
2. Press the "D" double function edit control [VPDL].
3. Rotate the T double function edit control (SEL) or use the UP/DOWN
keys to move the cursor " < " to the position you want to place the
volume pedal.
Please note that some effect Chains have a fixed volume pedal placement.
For details refer to the 'Chain List'.
After completing Volume
Pedal Placement
4. Press the "H" double function edit control [EXIT] to return to the
PROGRAM UTILITY MENU.
To Next Page
Loading...
Need help?
General
