2 Manual 2 (Effect ON/OFF Mode)
In Manual 2. effects can be switched ON and OFF by pressing the corresponding FC6
switch.
Selecting effects with FC6
switches (A to F)
Verifying ON/OFF status of
effects on the A1 display
Red LED lights up - Effect is ON
Green LED lights up - Effect is OFF
No LED - No effect
Effect name in uppercase, LED on - Effect is ON
Effect name in lowercase, LED off - Effect is OFF
• The FC6 cannot be used to switch the Ai's7lh effect ON and OFF when the
FC6 is connected; however, it is possible to switch the A1's 7th effect ON
and OFF with a foot switch connected to the A1's rear panel (see page 55).
3 Connecting Foot Switch 1 and 2 to the SW1 and SW2 Jacks
on the FC6 Rear Panel
Correspondence between A1
effects and FC6 switches
The following functions can be used by connecting a foot switch such as a PS-1 or PS-2 to
the SWI and SW2 jacks on the rear panel of the FC6, and the output of the KVP-OO1
volume pedal to the PEDAL1 and PEDAL2 jacks.
SW1: Switches between manual 1 and 2.
SW2: Turns the A1 bypass on and off.
PEDAL1: Controls the A1's volume (the same (unction as the VOL jack on the A1's rear
panel).
PEDAL2: Controls A1 parameters (the same function as the PARAM. jack on the A1's
rear panel).
To Next Page
Loading...
Need help?
General
