Saving (writing) A1 programs
Make sure beforehand that the write-protect switch on the RAM card is set to OFF.
to a RAM card
1. Insert the RAM card into the CARD slot.
“RAM CARD INSERTED” or “UNFORMATTED” will appear on the display.
Press (EXIT] and go to step 2.
2. Press the UTILITY Mode key to display the Global Utility Manu.
3. Press the "C" double (unction edit control [CARD].
4. Press the "D" double function edit control [SAVE].
When program saving is
completed
●
Unformatted RAM cards are automatically formatted during a save operation.
5. Press the "Q" double function edit control [YES] to proceed with program
saving, or the "H" double function edit control [NO] to cancel program saving.
If an error message is displayed, press the "H" double function edit control [EXIT] to
return to the Global Utility Menu.
For a list of error messages, see page 61.
6. When the program has been saved to the RAM card, "COMPLETED" is
displayed.
Press the "H" double (unction edit control [EXIT] to return to the GLOBAL UTILITY
MENU.
When you have finished saving the program, switch the write-protect switch on the RAM
card to ON.
To Next Page
Loading...
