Korg MPS-10 - CC PAD Mode; SET LIST Mode

MPS-10 - Playing the MPS-10
17
With the looper, you can record the same sound that’s output from the MAIN OUT L (MONO), R jacks
(what you play on the pads as well as the AUX IN/MIC IN input audio) for endless overdubbing.
You can freely switch between KITs while the looper is playing, which lets you overdub sounds from
different KITs or play different KITs while the looper is playing back.
Note: Note that the metronome can’t be recorded.
Note: When you press the SW MODE button while the looper is operating, the rec, overdub and erase rec opera-
tions stop, and the unit enters Playback mode.
CC PAD mode
You can use the CC pads to detect where you strike the pads and then use that data to control the
functions that you set.
The four functions that can be controlled by the CC pads include TRANSPOSE, NOTE DELAY, MFX and
FILTER.
In CC PAD mode, you can use the TRACK 1–4 buttons to temporarily switch these functions on/off.
Refer to “KIT EDIT menu” ( p.45) in this manual for the detailed settings.
SET LIST mode
When SW MODE button is lit, long-press the SW MODE button to turn the SET LIST function on.
You can use the SET LIST function to set the order in which the KITs are recalled as you like, without
the need to actually reorder the KITs.