MPS-10
-
Parameter guide
67
UTILITY menu
The UTILITY menu of the MPS-10 contains many functions and settings.
To use the UTILITY functions, press the UTILITY button to enter UTILITY mode.
If you’re accessing a page for which the UTILITY button is not lit, press the EXIT button repeatedly
until you get to a page where the UTILITY button lights up.
Setup
From this screen, you can configure the pad triggers, audio input/output, metronome, MIDI, display
indications and other functions.
Master Tune .............................................................................. 430 Hz...450 Hz
Lets you set the basic tuning of the MPS-10. (The default setting is “440 Hz”.)
Note:
When the “M.Tune” OSC setting for the INST is “ON”, Master Tune is enabled.
Sound off ......................................................................... All, Before KIT Change
Sets the function of the SOUND OFF button.
All: Stops the sound of all pads that are outputting sound.
Before KIT Change: Stops the sounds of the KIT you used before switching to a different KIT.
Edit PAD Auto Select................................................................................ On, Off
By striking the pad in the location where you can select the pad number, you can set whether to
enable the pad selection function.
Memory Protect ........................................................................................ On, Off
Sets whether to prohibit the internal memory from being written to (overwritten).
Note:
When this is on, you can’t overwrite the KITs, INSTs or SAMPLEs. You can use the looper, but you can’t use
the Write function to write any data.
Note:
You can save data in UTILITY mode (including looper setup and set list data) even when Memory Protect is
“ON”.
To Next Page
Loading...
