MPS-10
-
Parameter guide
55
INST edit menu
The parameters you can edit using the INST edit menu are shown below.
Note:
Some settings may produce distortion or noise.
PAD# ................................................................................1...10 / A,B,C,D / Pedal
Selects the pad for which you wish to edit the settings.
INST .........................................................................................................................
Selects the INST to be edited. The selected INST name is shown in brackets.
Level.............................................................................................................0...100
Sets the overall volume for the currently selected INST.
Transpose ................................................................................................ -24...+12
Sets the overall pitch for the selected INSTs.
BPM Refer to............................................... OSC1 BlockA...H, OSC2 BlockA...H
Selects the block that refers to the base BPM that’s used for the currently selected KIT.
OSC2........................................................................................................... On, Off
Enables/disables OSC2.
OSC1/2 Level...............................................................................................0...100
Sets the overall OSC volume for the currently selected INST.
OSC1/2 M.Tune............................................................................. Disable, Enable
This parameter determines whether to control or not control the pitch in sync with Master Tune in
UTILITY.
OSC1/2 Trigger Type ...................................................................Shot, Alternate
Sets the OSC trigger state for the currently selected INST.
Shot: The note plays again if you strike the pad while the sound is still playing.
Alternate: The note stops if you strike the pad while the sound is still playing.
OSC1/2 Mono/Poly ................................................................Poly, Mono, Repeat
Sets whether each OSC plays in mono, poly or repeat mode.
Note:
If only one of the OSC is set to “Repeat”, that INST becomes a “Repeat INST”.
Note:
For the OSC that’s set to “Repeat”, you can only select “Alternate”, not “Shot”.
To Next Page
Loading...
