Korg MPS-10 - Adjusting Sample Start and End Points

MPS-10 - Sampler
40
Adjusting the start point and end point
1 On the RECORDED SAMPLE page, a window appears that shows the sampled waveform.
2 Adjust the sample’s start position while using the VALUE knob to select Start, Scale,
Horizontal and Vertical zoom parameters.
3 Move the cursor to “Start” and press the ENTER button. When you’ve decided on the start
position, press the ENTER button again to confirm.
4 Adjust the end position in the same way.
You can use the to change the position, while setting a fixed interval for the Start/End positions.
You can use the to view the number of samples (size) between the start and end positions.