Korg MPS-10 - Editing Sample Data (Truncate)

MPS-10 - Sampler
41
5 Move the cursor to the BPM and press the ENTER button. A window is shown on the page,
where you can set the Measure (number of measures) and Beat (time signature). When you set
the Measure and Beat, the BPM is automatically calculated and shown.
If Measure is “Off”, the BPM is disabled.
6 You can check the adjustment as needed by using the track button transport function.
Move the cursor to select “OneShot” or “Repeat”. This parameter applies to the playback transport
function on this page.
Editing SAMPLE data
Once you’ve finished sampling, use the following steps to delete (truncate) the unwanted portions of
the SAMPLE data and to adjust (normalize) the SAMPLE to an appropriate level.
Note: If sampling ends because there isn’t enough free space in internal memory, the SAMPLE EDIT page can’t be
shown.
1 After you’ve adjusted the Start/End positions, press the EDIT button to show the SAMPLE
EDIT page.
2 On the SAMPLE EDIT page, select “Truncate...” and press the ENTER button to switch to the
Truncate page.
You can truncate in three different ways.