Korg MPS-10 - Editing Sample Menus; Creating New Samples and INSTs

MPS-10 - Sampler
38
Displaying the SAMPLE edit menu and
editing
Here’s how to sample a new sound to create a SAMPLE. The maximum recording time per SAMPLE is
60 minutes.
1 Press the SAMPLE button.
2 With the cursor positioned at “RECORDER”, press the ENTER button.
3 This accesses the RECORDER page. With the cursor positioned at “Make,” press the ENTER
button. You can now select from one of three sampling modes, as shown below.
change SAMPLE in INST: Creates a new SAMPLE, and exchanges it with the SAMPLE that’s set in
the INST that’s already registered.
new SAMPLE & INST: Creates a new SAMPLE and creates a new INST for which only that SAMPLE is
set.
only new SAMPLE: Creates a new SAMPLE only.
For this example, we select “new SAMPLE & INST”.
4 To choose the pad to strike when editing the SAMPLE, move the cursor to “PAD #” and specify
the pad number.
Note: The pad you last struck before entering SAMPLE edit is the target pad.
5 When the “Make” setting is “new SAMPLE & INST”, move the cursor to “INST” and press the
ENTER button to open the category selection page.
Select the category where you want to save the new INST. (You can also create new
categories.)