Korg MPS-10 - Looper FX Configuration

MPS-10 - Parameter guide
61
LOOPER Setup / TRACK
This screen lets you set the operating mode for each track.
Sync ...................................................................................................... Sync, Free
Sets whether the selected track operates in “Sync” mode (which synchronizes the track length and
the transport start/stop timing) or in “Free” mode (which lets you use a track length and operation
timing that’s not connected to other tracks).
Mode.............................................................................................. Loop, One Shot
You can set the looper for the selected track to operate in “Loop” mode (where the looper repeatedly
plays back) or in “One Shot” mode (where the looper plays back once and then stops).
Pan ............................................................................................. L16...Center...R16
Sets the panning position (the left-right volume balance) for the selected track.
Level..............................................................................................................1...100
Sets the volume of the selected track.
LOOPER Setup / FX
These settings are for configuring the looper effect.
FX On/Off ................................................................................................... On, Off
Enables/disables the looper effect.
Input Trim....................................................................................................0...100
Adjusts the input level of the looper effect. The sound may distort when using certain effect settings.
If this happens, use this parameter to adjust the level so as to avoid distortion.
OutPut Level.............................................................................................. 0...100
Adjusts the output level of the looper effect. As the output volume may change depending on the
effect settings, use this parameter to adjust the volume as appropriate.
FX Type....................................................................................................................
This selects a looper effect. (Refer to the “Effect type list” in the preset list (PDF))
Param1,2,3 ..................................................................................................0...100
The contents of Param 1, 2 and 3 differ depending on the FX Type.
For details on the parameters, refer to the “Effect type list” in the preset list (PDF).