MPS-10
-
Parameter guide
66
Function Type: Attack
Deletes the range of the SAMPLE from the beginning to the point at which the SAMPLE signal
reaches the set Threshold level.
Threshold......................................................................................................1...100
Sets the peak level of the start point.
SAMPLE EDIT / Pitch Edit
You can change the pitch of the SAMPLE.
Transpose ................................................................................................. -12...+12
Adjusts the pitch of the SAMPLE in semitones.
Tune .......................................................................................................... 0...+100
Adjusts the pitch of the SAMPLE in cents.
Time Correction......................................................................................... On, Off
When this is enabled, you can change the pitch while maintaining the SAMPLE length (time).
SAMPLE EDIT / Time Stretch
You can change the length of the SAMPLE here.
Time Offset ................................................................................. 30.00...300.00
Sets the length of the SAMPLE, based on its BPM value.
The setting range for the SAMPLE length is 30.00–300.00, limited to a range within 1/2–2x. You can-
not set the direction in which the SAMPLE is stretched when the length is set to 30.00. Also, you can-
not set the direction in which the SAMPLE is compressed when the length is set to 300.00.
For SAMPLEs without a BPM setting, a setting of “120” is shown.
Pitch Correction ........................................................................................ On, Off
When this is set to on, you can change the sample’s time while maintaining its pitch.
To Next Page
Loading...
