MPS-10
-
Turning the power on/off
12
Turning the power off
1
Turn the volume all the way down on any external output devices that are connected.
Lower the volume on the external output devices connected to this instrument, and then turn off
the power of these devices.
Turn the MAIN VOL. and PHONES knobs on this unit all the way down (counterclockwise) to mini-
mize the volume.
2 Keep holding the (Power) button on the MPS-10 down until the message “POWER OFF” is
shown in the display.
Once the display goes dark, the power turns off.
When you turn off the power, a popup message is shown that asks if you want to save or discard
your settings if you haven’t saved your edits yet.
To turn off the power without saving, press the ENTER button. To save the settings, press the
EXIT button to cancel the power-off action, save your settings, and press the power button again
to turn off the power.
Auto power-off function
The MPS-10 has an auto power-off function that automatically turns off the power if the pads have
not been played or if the front panel buttons and controls have not been used for a certain length of
time.
You can change the time it takes for the unit to turn off automatically, or disable the auto power-off
feature entirely.
1 Press the UTILITY button to enter UTILITY mode.
If you’re accessing a page for which the UTILITY button is not lit, press the EXIT button repeatedly
until you get to a page where the UTILITY button lights up, and then press the UTILITY button.
Do not unplug the AC adapter before the display goes dark. Doing so may cause a
malfunction.
To Next Page
Loading...
