MPS-10
-
Parameter guide
78
If there is already a file with the same name when you press “Execute”, the message shown below
appears.
To overwrite the data, press the ENTER button. To rename the data, press the EXIT button.
Note:
If you cancel the Export All User Data operation while it is in progress, the data with the specified name is
deleted from the USB flash drive.
Note:
SAMPLEs saved to this unit that have a long recording time might take a while to export when you use the
“Export All User Data” command.
Note:
To delete the data that’s saved, delete the subfolder with the name you specified in “Name,” located in the
“ALL_DATA” subfolder of the “MPS_10” folder.
Import & Export / SAMPLE
The MPS-10 lets you import external SAMPLE data by using a USB flash drive and then assign this
data to the pads, just like with the internal SAMPLEs.
The SAMPLEs that you create on this device can be exported as WAV files.
Note:
Supported SAMPLE data formats are WAV or AIFF (16-bit, mono/stereo, 44.1/48 kHz, up to 60 minutes long).
Move the cursor to “SAMPLE” on the Import & Export top page, and press the ENTER button to enter
the Import & Export page for “All User Data”.
How to import SAMPLEs
Here’s how to import the SAMPLE data saved on a USB flash drive into the MPS-10.
1 Import the SAMPLE data file that’s saved to the USB flash drive into internal memory.
Note:
Store the SAMPLE data files along with the folders that contain the SAMPLE data files in the “SAMPLE” sub-
folder, located in the “MPS_10” folder on the USB flash drive. Any other SAMPLE data files stored on the USB
flash drive are not imported into the MPS-10.
To Next Page
Loading...
