Korg MPS-10 - INST; Velocity

MPS-10 - Parameter guide
56
INST / Velocity
Sets the velocity curve for each OSC.
You can set the minimum, midpoint and maximum velocity, and edit the curves between these points.
These settings let you make changes to the volume according to how hard you strike the pads.
Tip: Press the EDIT button in the instrument’s edit menu page to go to the “Velocity” page, and press the EXIT
button to return.
Tip: There are three settings: “Velocity”, “Block Layout” and “Block Edit”. Use the METRONOME knob to switch
between setting pages.
EDIT OSC SELECT.............................................................................OSC1, OSC2
Switches between OSC on the same page to edit.
Note: When you select OSC1 and then switch pages, you can make the Block Layout and Block Edit settings for
OSC1.
V Response ................................................................................................ On, Off
Enables/disables the Velocity parameter for each OSC.
Velocity 1 ...................................................................................................... 1...127
Sets the velocity value of the first point for each OSC.
Level 1 ..........................................................................................................0...100
Sets the level of the first point for each OSC.
Curv A.......................................... Linear, Exp1, Exp2, Exp3, Log1, Log2, Log3
Sets the velocity curve from the first to the second point.
Velocity 2 ..................................................................................................... 1...127
Sets the velocity value of the second point for each OSC.
Level 2 .........................................................................................................0...100
Sets the level of the second point for each OSC.
Linear Log1
Exp1 Log2
Exp2 Log3
Exp3