MPS-10
-
Parameter guide
54
PAD EDIT menu
Use the METRONOME knob on the KIT EDIT menu page to switch between the PAD EDIT menu pages.
The parameters you can edit using the PAD EDIT menu are shown below.
PAD# ................................................................................1...10 / A,B,C,D / Pedal
Selects the pad for which you wish to edit the settings.
INST[---]..................................................................................................................
Selects the INST that’s set for the pad.
Tip:
The Loop/One Shot settings or the BPM may be shown, depending on the INST selected.
PAD Level....................................................................................................0...100
Sets the volume of the currently selected pad.
Pan ............................................................................................. L16...Center...R16
Sets the panning position (the left-right volume balance) for the currently selected pad.
Pad Mode ..................................Normal, Exclusive1,2, Series, Random, Latest
Sets the operating mode for the currently selected pad.
Normal: The normal state, in which the pad does not work in conjunction with other pads.
Exclusive1,2: With this setting, only one of the other pads in the same group can play at the same
time. The last pad that you struck plays, and all other pads that had been playing up to that point are
forcibly muted.
Series: Striking any pad in a group of pads sequentially triggers the other pads within the group.
Random: Striking any pad in a group of pads randomly triggers the other pads within the group.
Latest: The pad works the same as the last pad that was struck, instead of using its own settings.
Pitch Offset..................................................................................-24.00...+12.00
Adjusts the pitch of the currently selected pad.
Integers set the Transpose value (in semitones), and decimals set the Tune value” (in cents).
IFX Assign..................................................................................... Off, IFX1, IFX2
Sets the IFX through which the currently selected pad is routed.
PAD Copy /Paste
When you press the EDIT button, the PAD Copy/Paste window appears. You can copy the contents of
all the parameters of the selected pad to the clipboard, or paste the pad parameters in the clipboard
to the selected pad. You can also paste pad parameters that you copied from other KITs.
To Next Page
Loading...
