Korg MPS-10 - Page 53

MPS-10 - Parameter guide
53
Output Level ........................................................................................... 0...100%
Adjusts the output level of the Reverb. As the output volume may change depending on the Reverb
settings, use this parameter to adjust the volume as appropriate.
Reverb Type ............................................................................................................
Selects the reverb effect. (Refer to the “Effect type list” in the preset list (PDF))
Param1,2,3 ..................................................................................................0...100
The contents of Param 1, 2 and 3 differ depending on the Reverb Type. When you change the Type,
these parameters are reset to their default values.
For details on the parameters, refer to the “Effect type list” in the preset list (PDF).
FILTER
Tip: Press the EDIT button to move to the CC PAD/Filter page. ( p. 47, “FILTER”)
Filter On/Off............................................................................................... On, Off
Enables/disables the filter.
Input Trim................................................................................................ 0...100%
Adjusts the input level going into the filter. The sound may distort when using certain Filter settings.
If this happens, use this parameter to adjust the level so as to avoid distortion.
Output Level ........................................................................................... 0...100%
Adjusts the output level of the filter. As the output volume may change depending on the Filter set-
tings, use this parameter to adjust the volume as appropriate.
Filter Type ...............................................................................................................
Selects the filter type. (Refer to the “Effect type list” in the preset list (PDF))
Cutoff ...........................................................................................................0...100
Sets the frequency at which the filtering begins.
Resonance ...................................................................................................0...100
Adjusts how much the frequencies around the cutoff frequency are emphasized.