MPS-10
-
Parameter guide
47
Offset Param1 ..................................................................................... -100...+100
Offset Param2 .................................................................................... -100...+100
Sets the maximum offset value for the CC pads.
The parameter contents change according to the effect type set for the MFX.
CC PAD Assign ............................................................................................. (1...9)
You can set one of the nine patterns below, which are used for changing the parameter contents
according to where you strike the pads.
The corners of the triangles represent the minimum offset, and the sides of the triangles represent
the maximum offset.
Tip:
On the pads indicated in gray, the offset value is reset when you strike the location in question, which lets you
revert the parameter settings to those saved in the KIT.
Tip:
The setting for which the triangle is split in two is a symmetrical setting, which prevents the value from drift-
ing when you’re playing rolls with two sticks.
Transition ....................................................................................................0...100
Sets the speed at which the parameter value changes when you strike a CC pad.
FILTER
You can apply an offset to two of the Filter effect parameters (Cutoff and Resonance) in the MFX. This
offset changes according to where you strike the pads.
Note:
This is disabled if the Filter for Main FX is set to “Off”. Select the appropriate Filter type and then set the Fil-
ter to “On”.
Tip:
Press the EDIT button to jump to the Filter page of Main FX.
Filter ........................................................................................................... On, Off
Enables/disables the Filter function.
Cutoff Freq .......................................................................................... -100...+100
Sets the maximum offset value for the filter’s cutoff frequency, when using the CC pads.
Resonance ........................................................................................... -100...+100
Sets the maximum offset value for the filter’s resonance, when using the CC pads.
To Next Page
Loading...
