MPS-10
-
Appendix
97
• It may take a while to import many SAMPLEs or SAMPLEs with a large file size.
• You can store up to 10,000 SAMPLEs on this unit. You can import more new SAMPLEs by delet-
ing unwanted SAMPLEs or overwriting existing SAMPLEs.
Can’t export All User Data or SAMPLEs to the USB flash drive
• The All User Data function includes all the user data including the SAMPLEs. As a result, the
file size tends to be large. Check whether there is enough free space on the USB flash drive
(export destination) to accommodate the export file size.
• It may take a while to export many saved SAMPLEs or SAMPLEs with a large file size.
BPM information is not included in the imported SAMPLE data
• In Sample mode, import the sample file on the Sample page, set “SAMPLE BPM” and save.
The Looper and SET LIST settings are erased when the power is turned off
• As the Looper and SET LIST parameters are found in UTILITY, execute UTILITY Write to over-
write the values.
LCD screen or LEDs are too dark or bright
• Adjust the LCD or LED brightness from Setup / Display.
Pedals are not operating as expected
• Calibrate the pedals.
When external pads are connected to the TRIGGER IN CH A/B or C/D jack and I
play two pads at the same time, I only hear sound from one pad
• The MPS-10 is configured by factory-set default to cancel out the resonance from other pads
when a pad sounds.
In UTILITY / Setup PAD Trigger, set Xtalk Cancel to “Off”.
Effects are not applied even when IFX is ON
• To apply the IFX, select a pad for which effects are applied on the PAD EDIT page; and in IFX
Assign, set whether IFX1 or 2 is applied.
To Next Page
Loading...
