MPS-10
-
Parameter guide
58
Round Robin............................................................................................... 1...8set
Sets the number of round robins for the selected layer. Although there is a maximum of eight sets,
you can use the “Layer #” setting shown above to change the “Round Robin” maximum value.
Block ............................................................................................................... A...H
Selects the block to edit. You can edit up to eight blocks for each OSC.
Level.............................................................................................................0...100
Sets the level for the selected block.
SAMPLE ..................................................................................................................
Selects the SAMPLE to be used for the selected block. The selected SAMPLE name is shown in brack-
ets. If BPM data is included in the SAMPLE, the BPM is also shown.
INST / Block Edit
Use this screen for editing a maximum of eight registrable blocks.
Blocks with the same velocity layer are marked with a white underline.
Unused blocks are grayed out.
Block ............................................................................................................... A...H
Selects the block to edit. You can edit up to eight blocks for each OSC.
When you move the cursor to a block and press the ENTER button, that block is selected and high-
lighted, and its contents are shown below.
SAMPLE ..................................................................................................................
Selects the SAMPLE to be used for the selected block. The selected SAMPLE name is shown in brack-
ets. If BPM data is included in the SAMPLE, the BPM is also shown.
Tip:
This works in conjunction with “SAMPLE” on the “Block Layout” page.
Level.............................................................................................................0...100
Sets the level for the selected block.
Tip:
This works in conjunction with “Level” on the “Block Layout” page.
Transpose ............................................................................................... -24...+12
Sets the Transpose for the selected block.
Tune .............................................................................................................0...100
Sets the Tune for the selected block.
Envelope ...................................................................................................... On Off
Sets the envelope for the selected block. When Envelope is turned on, the Attack Time, Decay Time
and Decay Curve are enabled.
Attack Time ................................................................................................0...100
Sets the Attack Time for the selected block.
To Next Page
Loading...
