Korg MPS-10 - Expression Pedal Calibration

MPS-10 - Parameter guide
75
Exp Pedal
Use the METRONOME knob to switch to the Exp Pedal page.
Function..................................... Off, Looper Volume, Filter Cutoff, Reverb Mix
Sets the function that’s assigned to the expression pedal connected to this instrument.
Min.................................................................................................-100%...+100%
Set the minimum value for the pedal.
Max................................................................................................-100%...+100%
Set the maximum value for the pedal.
Curve............................................. Linear, Exp1, Exp2, Exp3, Log1, Log2, Log3
Selects one of seven settings for the pedal output value curve.
Pedal Calibration
Select “Pedal Calibration” to calibrate the pedal that’s connected.
How to calibrate the pedal
You can select “Pedal Calibration” to calibrate the expression pedal that’s connected.
1 With the pedal pushed all the way down with your toes (maximum position), press the ENTER
button.
2 With the pedal pushed all the way down with your heel (minimum position), press the ENTER
button.