MPS-10
-
Parameter guide
82
5 Move the cursor to “Execute” and press the ENTER button. A message is shown on the page,
confirming whether you want to export the selected SAMPLE. Press the ENTER button to
execute. Press the EXIT button to cancel.
Note:
If there is already a file with the same name when you press “Execute”, the message shown below appears.
To overwrite the existing data, press the ENTER button. To go back and rename the data, press the
EXIT button.
Note:
When you cancel the export SAMPLE operation, the export stops and the file currently being exported is
deleted from the USB flash drive.
Note:
To delete the data that’s saved, delete the WAV file with the name you specified in “Name,” located in the
“SAMPLE” subfolder of the “MPS_10” folder on the USB flash drive.
Import & Export / LOOPER Data
“Looper data” refers to the collection of saved audio data from the four tracks, as well as the looper
setup parameters.
Move the cursor to “LOOPER Data” on the Import & Export top page, and press the ENTER button to
enter the Import & Export page for “LOOPER Data”.
How to import looper data
Here’s how to import all looper data into internal memory from a USB flash drive.
To Next Page
Loading...
