MPS-10
-
Parameter guide
94
Note:
If there is no system data for updating on the USB flash drive or if the USB flash drive is not inserted, the
following message appears.
Saving the UTILITY settings
To save the UTILITY settings you’ve edited, you must write them.
Tip:
The looper edit parameters are also UTILITY parameters, so you can save them as well by writing the utility
parameters.
When you press the WRITE button on a page in UTILITY for which no message is shown, a message is
shown for saving all the UTILITY settings to the MPS-10.
The settings you save here will be the default UTILITY settings the next time you turn on the power,
so make sure to save them before turning off the power.
Tip:
The data that’s saved includes Setup, LOOPER, SET LIST and Function Assign.
Tip:
You can save the UTILITY settings even when Memory Protect is “ON”.
To Next Page
Loading...
