Korg MPS-10 - Page 24

MPS-10 - Editing the KITs
24
4 With “Destination” selected, press the ENTER button to see the page on which you can specify
where to save the KIT.
Press the ENTER button to confirm the selection to save the KIT, or press the EXIT button to cancel.
5 Press the WRITE button again once you’ve confirmed the KIT name and the save destination.
An alert window appears as shown here. To write the data, press the ENTER button. To cancel,
press the EXIT button.
6 If the write operation is successful, the KIT changes to the save destination KIT, and the screen
switches to the top page in KIT mode.
Tip: If you press the EXIT button to cancel the write operation and close the window and then press the EXIT but-
ton again, you can return to the previous page before the write operation begins.
Using the Name dialog box (how to change the name)
With “Name” selected, press the ENTER button to show the screen where you can edit the name of
the KIT and so on.