MPS-10
-
Editing the KITs
30
5 On the INST WRITE screen, move the cursor to “Search the referencing KITs...” and press the
ENTER button to check which KIT or KITs are using the INST that’s referenced by “Desti-
nation”.
Tip:
If many KITs are referencing that INST, use the VALUE knob to scroll through the list.
6 Press the WRITE button again once you’ve confirmed the INST name to save and the save
destination. An alert window appears as shown here. To write the data, press the ENTER
button. To cancel, press the EXIT button.
7 If the write operation is successful, the INST is newly registered, and the screen switches to
the top page.
Note:
If you recall and edit an INST here that’s not assigned to a pad, the INST assignment to the pad changes for
the KIT. In this case, the KIT button blinks to indicate that the KIT has been edited. Write the KIT to memory if
necessary. ( p. 23, “Saving a KIT”)
Note:
If you press the EXIT button to cancel the save operation and close the window and then press the EXIT but-
ton again, you can return to the previous page before the write operation begins.
To Next Page
Loading...
