Korg MPS-10 - Page 32

MPS-10 - Using the Looper function
32
Track 1 keeps playing back in a loop.
6 Press the track 1 button again to stop playback.
Record track 2 in the same way as a loop.
7 When recording track 2, you can set the length of the track’s loop.
You can set the track length for loop recording as a multiple of track 1.
In this example, we use the “x2” setting to make the loop twice as long as track 1.
8 Record to track 2 using the same steps as you used for track 1.
On track 2, once you’ve recorded for twice the length of track 1, the unit switches to overdub
mode.
Repeat these steps to record tracks 3 and 4.