Korg mr-2 - Selecting Parameters and Setting Values

6
Selecting parameters and setting values
OntheMR‐2,youcanselectparametersandsetvaluesbypressingthe
controllerbuttons.Whenyouselectanitemonthescreenusingacontrol‐
lerbutton,theselectionicon“”or“”willmovetotheselecteditem.
Icon“”indicatesthatanadditionalsettingscreenwillappearwhenyou
presstheCo
nfirmationbutton(thecentercontrollerbutton).
Toselectparametersorsetvalues,youwillpressthecursorleft/right/up/
down(// /)buttonstomovetheselectioniconormodifya
value.Toconfirmasetting,youwillpresstheConfirmationbutton(the
centercontrollerbutton).Inthismanual,thisse
riesofoperat
ionsiscalled
“selectandconfirm.”
Dependingontheparameter,selectingandconfirminganitemmaycause
afurthersettingscreentoappear,ormaycauseacheckmarktoappearin
acheckbox.
Ifyou’vemadeasettinginafurthersettingscreen,youcanpressthe
menubu
ttonto
returntothepreviousscreen.
Selection icon
Push
Push
Push