Korg mr-2 - Software Update Procedure; Performing the Software Update

44
Update procedure
YoumustusetheUSBbustopowertherecorderduringthis
updateprocedure.Otherwise,anerrormessagewillbedisplayed
andyouwillbeunabletoupdate software.
Ifapowerfailureorsimilaraccidentoccurswhileloadingthesys‐
tem,theMR‐2maybecomeinoperable.Ifthisoccurs,pleasecon‐
tactKo
rg
distributor.
1. Pressthemenubutton,andinthemenulist(MENU)screen,usethe
controllerbuttonstoselectandconfirm“SYSTEM.”
Thesystemsetting(SYSTEM)screenwillappear.
2. Usethecontrollerbuttonstoselectandconfirm“SoftwareUpdate.”
Adialogmessageof“Upgradingthesystem.Areyousure?”will
appearinthesc
reen
.
3. Usethecontrollerbuttonstoselectandconfirm“Yes.”
Thescreenwillindicate“SoftwareUpdate:Working...”andthe sys‐
temwillbeloaded.
Whenthesystemhasfinishedloading,thedisplaywillindicate
“SoftwareUpdate.Completed.”
4. PresstheConfirmationbutton(thecentercontrollerbutton);the
MR‐2willshutdownandthepowerwill
turnoff.
5. Slidethepowerbuttontoturnonthepower;theMR‐2willstartup
withthenewlyloadedsystem.
Iftheupdatefails,amessagewillappear.Makeanoteofthecon‐
tents,andtaketheappropriateaction(referto“Variousmessages”
onpage53).
Push
Push
Push