32
3.
Release the DUP button.
e step information you selected in step 1 will be copied to the step(s) you selected in step 2.
Selecting steps to be muted
You can mute the steps you don’t want to hear during playback (when the REC button is dark) or
when the SEQUENCER page is not displayed. Press the buttons from STEP 1–16 you wish to mute to
turn them o. Although the notes of steps that are turned o will not play back, the motion sequenc-
er will play back, and the sequence length will not change.
Tip:
If you press the STEP 1–16 buttons while the SEQUENCER page is displayed, the buttons
will function as step selectors.
• Step jump
While holding down the SHIFT button, press a STEP button to make the sequence jump to that
step. is will make the sequence shorter.
Editing note information for a step
If you press the STEP 1–16 buttons while the REC button is lit or while the SEQUENCER page is
displayed, the step corresponding to the button you pressed will be selected, and the SEQ NOTE page
will display. See “SEQ NOTE (Sequencer Note)” on page59.
Tip:
Each time you press a STEP button you selected while holding down the SHIFT button, the
step’s “GATE” value increases by 25%.
Use the steps below to edit the note number or velocity value for each note.
1.
Hold down the SHIFT button and press the PITCH/SEQ button.
2.
Press the PAGE < and > buttons to display the SEQ NOTE page.
3.
Press one of the STEP 1–16 buttons to select the step to edit.
e STEP button that you selected will blink.
4.
Use the DATA ENTRY A knob to select the note you want to edit.
e selected note is shown in highlighted text on the le side of the display.
5.
Use the DATA ENTRY B–F knobs to change the parameters.
Tip:
“ACTIVE” is set for each step, and cannot be changed for each note. When you want to
delete only a certain note, hold down the SHIFT button and turn the DATA ENTRY B knob
to set the “NOTE” to “---”.
To Next Page
Loading...
Need help?
General
Weight and Dimensions
