12. If the status indicator continues flashing a couple minutes after the
software is fully loaded or the message “CardioCoach Not
Connected” in the lower left corner of the software continues to
display, see the Troubleshooting section of this manual.
13. Connect the power source to the CardioCoach PRO. Power on the
CardioCoach PRO.
14. The status indicator (the green LED to the left of the two testing ports
as shown on the diagram in the Product Overview section of this
manual) flashes to indicate there is no connection.
15. Ensure that the CardioCoach software is running on the PC or tablet.
16. The message, “CardioCoach Not Connected” is displayed in the
lower left corner of the CardioCoach software.
17. Use a USB cable to connect CardioCoach PRO to the PC or tablet.
18. Wait for Windows to recognize and configure the CardioCoach PRO.
If a Windows message appears in the lower right corner of your
screen to “click here to finish setting up your device,” ignore it. The
status indicator light on the unit will continue flashing as before.
19. Run the CardioCoach software. The message, “CardioCoach Not
Connected” is displayed in the lower left corner of the CardioCoach
software.
20. After a few seconds, the software should recognize and connect to
the CardioCoach PRO. When connected, the status indicator will stay
lit and the message “CardioCoach Not Connected” will change to
“Connected.”
21. If the status indicator continues flashing for a few minutes after the
software is fully loaded, and if the message in the lower left corner of
the software continues to say “CardioCoach Not Connected,” check
the USB cable and replace if necessary. Also see the
Troubleshooting section of this manual.
Note: You may wish to connect your heart rate monitor during
setup, especially if using a heart rate monitor other than the one
originally provided with your CardioCoach. You may also
connect your heart rate monitor after starting the testing
process.
To Next Page
Loading...