CardioCoach User Manual | Page 29
Section 3
CardioCoach PRO Operation
Powering On and Off
Turn the CardioCoach PRO unit on by flipping the switch on the back of the
unit.
The red power LED on the front panel of the CardioCoach PRO will verify
the power connection of the CardioCoach PRO.
VO
2
Max Exercise Testing
Client Preparation Prior to Arrival
Proper client preparation is important for successful testing and reliable
results. The following guidelines are recommended:
1. Have the client complete the Participation Activity Readiness
Questionnaire (PARQ) to determine their eligibility for testing. A copy
of this form in located under Forms or in the software by navigating
to Help -> Forms from the main menu.
2. The client should be dressed appropriately in comfortable exercise
attire.
3. Instruct the client to refrain from exercise or endurance training for
12 hours prior to test.
4. The client should avoid food, tobacco, alcohol, and caffeine for at
least 3 hours before testing.
5. Water may be taken as needed at any time.
6. The client should continue prescription medications as usual.
Client Preparation upon Arrival
1. Properly fit the mask, as instructed below.
a) Determine the correct size of mask by placing the faceplate over
the client’s nose and mouth.
b) Look for adequate coverage around the nose and mouth.
2. Attach the Y-valve to the mask face plate at the round opening by
threading the valve into the grooves of the mask, as illustrated below.
Note that the valve will be very tight against the mask and may
require some effort to secure properly.
Note: The mask should not be too large so that it expands over
the eyes or past the chin.
To Next Page
Loading...