Installation and Settings
CardioCoach PRO User Manual | Page 76
Coded Heart Rate Monitor only:
Ensure heart rate plug is fully
inserted into Heart Rate Input Jack.
3. Follow any troubleshooting steps in the user manual for your heart
rate monitor.
No Heart Rate Found
The battery in the heart rate monitor may have exhausted just before the
connection was finished, or there may be interference with the Bluetooth
signal. Click Try Again. If the error persists, see Bluetooth Heart Rate
Monitor Does Not Connect with CardioCoach Software in this manual.
Failed to read heart rate
It is possible that the device selected from the list is not a heart rate
monitor. Otherwise, click Click Try Again. If the error persists, see
Bluetooth Heart Rate Monitor Does Not Connect with CardioCoach
Software in this manual.
Failed to connect to heart rate monitor
It is possible that the device is powered off and it was selected before the
list had time to update. Inactive heart rate devices often appear on the
device list in the first few seconds, so you may need to wait a moment
before selecting a device from the list to ensure that the desired device is
active. Click Refresh List and search for another heart rate monitor. If the
error persists, see Bluetooth Heart Rate Monitor Does Not Connect with
CardioCoach Software in this manual.
Error Codes
Flow port
obstructed.
Unit beeps and
flashes light above
obstructed port.
Remove hose, mask, or cap from the indicated port.
Place cap on indicated port.
Note: The Bluetooth device you selected may not offer a heart rate
service.
Note: The heart rate monitor you selected may not be supported.
Note: The Bluetooth signal may have been lost before connection was
completed.
To Next Page
Loading...