Installation and Settings
CardioCoach PRO User Manual | Page 16
3. Navigate to Help from the top menu, then About.
4. Make sure your BLE heart rate monitor is powered on.
5. Click the Heart Rate Device button.
6. Wait for your heart rate monitor to appear in the list of BLE devices,
and then select it.
7. If you get an error message or do not see your BLE heart rate monitor
on the list, you may click the Heart Rate Device button and try again.
8. If your BLE heart rate monitor still does not appear on the list, try the
following:
a. Review the steps outlined in the Position the Heart Rate Strap
section of the manual.
b. Check and/or replace the battery in the heart rate monitor.
c. Heart rate monitor straps wear out over time and a new one
may be needed.
d. Reduce or remove other BLE devices in the area that may be
causing interference.
9. If issues persist, see the Troubleshooting section of this manual.
Connecting Exercise Equipment
1. Follow the instructions in your exercise device’s (Treadmill
/Ergometer) user manual for physically connecting it to your
computer.
2. Run the CardioCoach software.
3. Navigate to the Settings page.
4. Select Equipment Interface from the list of settings options.
5. Select desired exercise equipment from the list.
6. Select the COM port that you connected the equipment to in step
Connecting ANT+
1. ANT+ dongle needs to be plugged into USB port of computer. This will act
as an antenna/receiver for your piece of equipment.
Note: Pairing the BLE heart rate monitor using the Windows
Add Bluetooth or other device setup process is unnecessary.
CardioCoach software automatically searches for and
connects to the heart rate monitor.
Note: It may take a while for the list of BLE devices to generate.
If you do not see your heart rate device listed, wait until you see
the message "Enumeration Complete" before clicking refresh.
Note: Most heart rate monitors must be properly fitted and
strapped to a client before they will connect to the CardioCoach.
To Next Page
Loading...