KORR CardioCoach PRO - Page 78

Product Overview
Installation and Settings
CardioCoach Operation
Important Notes
Quality Test Procedures
Maintenance
CardioCoach PRO User Manual | Page 77
CODE
ERROR
SOLUTION
Unit beeps and
flashes red light
above open port.
1010
Barometric
Pressure Error.
Cycle power on the unit. If error persists, contact
KORR at www.korr.com/support/service to arrange
for service at the nearest KORR authorized service
center.
1011
Relative Humidity
Error.
Cycle power on the unit. If error persists, contact
KORR at www.korr.com/support/service to arrange
for service at the nearest KORR authorized service
center.
1012
Temperature Error.
Cycle power on the unit. If error persists, contact
KORR at www.korr.com/support/service to arrange
for service at the nearest KORR authorized service
center.
1013
Differential
pressure sensor
error reported by
sensors.
Cycle power on the unit. If error persists, contact
KORR at www.korr.com/support/service to arrange
for service at the nearest KORR authorized service
center.
1020
SD Card Error.
Cycle power on the unit. If error persists, contact
KORR at www.korr.com/support/service to arrange
for service at the nearest KORR authorized service
center.
1021
SD Card Full.
Cycle power on the unit. If error persists, contact
KORR at www.korr.com/support/service to arrange
for service at the nearest KORR authorized service
center.
1030
CO2 Unit Error.
CO2 unit has
reported an error.
Cycle power on the unit. If error persists, contact
KORR at www.korr.com/support/service to arrange
for service at the nearest KORR authorized service
center.
1031
CO2 Unit Error.
CO2 not
measuring.
Cycle power on the unit. If error persists, contact
KORR at www.korr.com/support/service to arrange
for service at the nearest KORR authorized service
center.
1003
Flow zeroing error.
Could not zero the
flow.
Cycle power on the unit. If error persists, contact
KORR at www.korr.com/support/service to arrange
for service at the nearest KORR authorized service
center.