115
6
© 2018 KOSTAL Solar Electric GmbH
System monitoring
Logging into the Webserver
Launch an Internet browser.
1. Enter the IP address of the inverter in the address line
of the browser and confirm with "Enter".
P
The Webserver is called up.
2. As a plant owner, log in with your password.
If you want to log in as an installer, enter the following
data:
Master key: Master key from type plate
Service code: Installer’s service code
Confirm the danger notice and exclusion of liability.
P
The Webserver's menu opens.
Making settings in the Webserver
After logging in, the settings required via the Webserver
can be made on the inverter or the inverter’s values can
be queried.
TIP
The IP address is shown alternately in
the inverter display or can be queried
in the inverter menu.
IMPORTANT
INFORMATION
To log in for the first time as a plant
owner, you first have to have a pass-
word. This can be obtained using
“Forgotten password”. In the following
menu, enter the master key and a
new password. You will find the mas-
ter key on the inverter’s type plate.
The password must comprise at least
8 characters
and include the following
combination of characters: a-z, A-Z,
0-9
Should you forget your password, it
can be re-assigned in the same way.
To Next Page
