Kostal PLENTICORE plus - Making Settings in the Webserver

75
3
© 2018 KOSTAL Solar Electric GmbH
Installation
3.15 Making settings in the Webserver
After the initial installation, more settings can be made
using the inverter’s menu or more conveniently via the
Webserver.
To do this, use your PC or tablet to log into the
Webserver as an installer.
Ch. 6.1.
The following settings should be made after the initial
commissioning:
n
Inverter settings made by installer
n
Prescribed settings for grid feed-in from energy sup-
ply company.
n
Registration on the KOSTAL (PIKO) Solar Portal, if
this has not yet been done.
n
With a battery connected, select the battery type and
undertake battery configuration.
n
Make further settings, such as changing the pass-
word or updating the inverter software.
INFO
Parameters governed by the grid,
limitations and guidelines can only be
modified with a service code
To log in as an installer, you need the
master key from the inverter’s type
plate and your service code, which
can be requested from our service
team.
Ch. 13.2
2
3
4
5
6
7
8
9
10
11
12
13
1