Kostal PLENTICORE plus - Page 151

151
7
© 2018 KOSTAL Solar Electric GmbH
General information
Prerequisites for data transfer to a solar portal:
H
Inverter has an Internet connection
H
Logged onto a solar portal (e.g. KOSTAL (PIKO) Solar
Portal)
H
Selection of a solar portal
H
Activation of data transfer in the inverter
Activating data transfer to a solar portal via the
control panel
1. Select the "Settings/information" menu
on the control panel of the inverter.
2. Confirm with the "ENTER" key.
3. Use the "UP", "DOWN" and "ENTER" keys to select
the “Solar portal” > “Portal” menu.
4. Select a solar portal
5. Press and hold down the "ENTER" key.
6. Select the "Activate" field and confirm with "ENTER".
H
Data transfer to the solar portal is now enabled. The
name of the solar portal is displayed. The data export
to the solar portal is being executed.
INFO
A correctly set-up network connec-
tion/Internet connection is a prerequi-
site for data transfer
It may take as long as 20 minutes
following activation (dependent upon
the portal) until the data export is
visible on the solar portal.
The KOSTAL (PIKO) Solar Portal
(www.kostal-solar-portal.de) is preset
as a standard solar portal.
2
3
4
5
6
7
8
9
10
11
12
13
1