Part 2: Overview of display values and settings General area
15
! Please do not enter the day of travel as the start
date, but the first day of the holiday (no more
heating from this day).
! Please do not enter the day of travel as the end
date, but the last day on which there is to be no
heating. When you arrive home the house should be
warm and there should be hot water.
! Stop holiday function => e.g. for early return by
pressing the program switch.
! Not with Time Master or DCF
! The default setting is valid for Central European time
zones. A modification is only required if the date for
the time change is changed by political decree.
! The earliest date on which the change will occur
must be set. The controller performs the time
change on the Sunday following this date at 2.00 am
or 3.00 am.
! If no time change is required, please set
MONTH STOP to the same value as MONTH
START and DAY STOP to the same value as
DAY START.
Holiday => Value group
(General -> Date/Time/Holiday level)
All the values in this level are set in sequence => adjust
using Ç => continue with Ä
YEAR START Set current holiday start year
MONTH START Set current holiday start month
DAY START Set current holiday start day
YEAR STOP Set current holiday end year
MONTH STOP Set current holiday end month
DAY STOP Set current holiday end day
Summer time => Value group
(General -> Date/Time/Holiday level)
All the values in this level are set in sequence => adjust
using Ç => continue with Ä
MONTH START Set month for start of summer time
DAY START Set earliest day for start of summer
time
MONTH STOP Set month for start of winter time
DAY STOP Set earliest day for start of winter time
To Next Page
Loading...