MAL-OPS-1026 v3 46
Brightness can be set at any value
between 20 and 100. Brightness cannot be
set as 0, as this would make the screen
unreadable.
If the value is set at a level which is lower
than the acceptable level, the numbers
will appear red, and the user will not be
able to select “OK”.
The idle timeout setting allows a user to set the time that the device must remain
inactive for before it enters sleep mode. The value can be set as 0 if the device
screen should always remain on and the device should never enter sleep mode.
To Next Page
Loading...