Krone EasyCut F 360 - Maintenance Table

Maintenance
55
Pos: 103.9 /Übersc hriften/Überschrif ten 2/U-Z/ WWartungstabelle @ 65\m od_13003694130 64_78.docx @ 583966 @ 2 @ 1
11.3 Maintenance table
Pos: 103.10 /BA /Wartung/Mäh werke/Wartungst abelle - Eas yCut ohne Rei bkupplung @ 204 \mod_1386162 833996_78.doc x @ 17024 54 @ @ 1
Maintenance work
Maintenance interval
Once after 10 hours
Before the beginning of the season
Every 10 hours but at least 1x daily
Once after 50 hours
Every 50 hours
Every 200 hours
Cutter bar
Oil level check
X
X
Oil change
not required
All gearboxes
Oil level check
X
X
Oil change
X
X
Checking cutter blades
X
X
Check retaining bolts for cutter blades
X
X
Check material thickness of leaf spring, for blade quick
fastener design
X
X
Cutting disc / blade drum
X
X
Linings on the cutter bar
X
Tightening screws / nuts
All screws
X
X
Friction clutch
Vent
X
Guard cloths
Check guard cloths for wear and damage
X
Drive belt
Check
X
Pos: 103.11 /Layo ut Module /---------------Seitenumbruch---------------- @ 0\mod_1196 175311226_0.d ocx @ 4165 @ @ 1