Krone EasyCut F 360 - Index

Index
93
19 Index
A
Abrasion Limit ..................................................... 77
Adjusting Skids ................................................... 87
Adjusting the Compensation Springs ................. 53
Adjusting the cutting height ................................ 51
Affixing the Adhesive Safety and Information
Labels ............................................................. 19
After Shearing Off ......................................... 60, 64
Aligning the Cutter Bar ........................................ 70
Ambient Temperature ......................................... 30
Angular gearbox ........................................... 66, 67
Attached devices ................................................ 13
B
Before mowing .................................................... 48
Before the Start of the New Season ................... 85
Blade Changing on Cutting Discs ....................... 78
Blade Quick-Fit Device ................................. 74, 80
Blade screw connection ...................................... 73
Blade Screw Connection .................................... 79
C
Checking the Cutter Blades and Blade Holder ... 72
Checking the First fitting ..................................... 39
Commissioning ................................................... 31
Connecting the hydraulic lines ............................ 44
Consumables ...................................................... 30
Contact................................................................ 18
Conversion for mowing steep slopes .................. 90
Conversion to narrower swathing ....................... 88
Cutter Blades ...................................................... 72
D
Dangers in Case of Non-compliance with the
Safety Instructions .......................................... 11
Detaching the machine ....................................... 50
Deviating torque .................................................. 57
Dimensions .......................... 24, 25, 26, 27, 28, 29
Direction Information ............................................. 7
Directories and References .................................. 6
Disposal of the machine ..................................... 92
Driving and Transport ......................................... 46
F
Filling Quantities and Lubrication Designations for
Gearboxes ...................................................... 30
First installation ................................................... 31
Fitting the guard cloths ....................................... 32
Friction Clutch ..................................................... 86
Further applicable documents ............................. 6
H
How to use this document ................................... 6
Hydraulic system ................................................ 15
Hydraulics .......................................................... 44
I
Identification Plate .............................................. 18
Inadmissible Modes of Operation ...................... 15
Information Required for Questions and Orders 18
Install the PTO shaft .......................................... 41
Installation of the lighting system ....................... 35
Installation of Weiste triangle ............................. 34
Intended Use ...................................................... 10
L
Lighting .............................................................. 46
Lighting connection ............................................ 43
Lower suspension arm ....................................... 38
Lubrication Chart ................................................ 83
M
Machine overview .............................................. 16
Maintenance ................................................ 15, 54
Maintenance – lubrication chart ......................... 82
Maintenance table .............................................. 55
Means of representation ...................................... 7
Notes with information and recommendations . 9
Warning signs ................................................... 9
Means of Representation
Figures ............................................................. 7
Metric Thread Screws with Control Thread ....... 56
Metric Thread Screws with Countersunk Head
and Hexagonal Socket ................................... 57
Metric Thread Screws with Fine Thread ............ 57
Minimum tractor requirements .. 24, 25, 26, 27, 28,
29
Mounting and adjusting the relief springs .......... 42
Mounting onto the Tractor .................................. 37
Moving the guards into the working position ..... 49
Mower Drive Gearbox .................................. 68, 69
O
Oil level check and oil change on the cutter bar 70
Operation ........................................................... 48
P
Periodical Inspection of the Cutting Discs / Blade
Drums............................................................. 76
Periodical Inspection of the Leaf Springs .......... 75