Special equipment
87
Pos: 143 /Übersc hriften/Überschrif ten 1/P-T/ Sonderausstatt ung @ 2\mod_12 02808469779 _78.docx @ 61 649 @ 1 @ 1
17 Special equipment
Pos: 144 /Übersc hriften/Überschrif ten 2/P-T/ SSpezielle Sich erheitshinweise @ 0\mod_119 6660495760_ 78.docx @ 9134 @ 2 @ 1
17.1 Special Safety Instructions
Pos: 145 /BA/Sich erheit/7. Gef ahrenhinweise alt/M ähwerke/War nung - Repar atur_Wartung _Reinigungs_4 allgemein Eas yCut @ 292\m od_14109414 23112_78.doc x @ 2299026 @ @ 1
WARNING!
When performing repair, maintenance or cleaning work or in case of technical
intervention, drive elements may start moving (caution: cutting discs continue to run).
Effect: Danger to life, injuries or damage to the machine.
• Turn off the PTO shaft.
• Move the machine to the working position and lower it to the ground.
• Switch off the engine of the tractor, remove the ignition key and carry it with you.
• Secure the tractor against accidental start-up and against rolling.
• After the repair, maintenance, cleaning work or technical modifications are completed,
mount all protective covers and safety devices properly again.
• Avoid skin contact with oils, greases, cleaning agents and solvents.
• In the event of injuries or burns due to oils, cleaning agents or solvents, contact a physician
immediately.
• All other safety instructions must also be followed to avoid injuries and accidents.
Pos: 146 /BA/So nderausstatung/E asyCut / AM M ähwerke/H ochschnittkufen EasyCut @ 3\ mod_1204783 761105_78.docx @ 72974 @ 2 @ 1
17.2 Adjusting Skids
Fig.
Adjusting skids can be used to increase the cutting height (see chapter entitled "Adjusting the
cutting height")
To do this, insert the adjusting skids (3) into the glide skids (2) and screw them in place. The
adjusting skids must always be mounted underneath the mowing discs that run next to the
mower drum.
Pos: 147 /Layou t Module /---------------Seitenumbruch---------------- @ 0\mod_11 96175311226 _0.docx @ 4165 @ @ 1
To Next Page
Loading...
