Krone EasyCut F 360 - Page 89

Special equipment
89
• Install the plates (1,2). Make certain when attaching the plates that the distance from the
rubber pads (7) to the mower drums is at least 3 mm.
Note - Reinstallation is in the reverse order
Before starting up the machine again, make certain to check the cutter blades, retaining bolts,
cutting discs, and drums as well as the linings
• See Maintenance section “Checking the Cutter Blades and Retaining Bolts”.
• See Maintenance section “Periodical Inspection of Cutting Discs and Drums."
• See Maintenance section “Replacing the Linings".
Pos: 148.2 /La yout Module /---------------Seitenumbruch---------------- @ 0\ mod_11961 75311226_0.doc x @ 4165 @ @ 1