Krone EasyCut R 360 User Manual

Table of Contents
4
8 Start-up .................................................................................................................................................. 28
8.1 Mounting onto the Tractor ................................................................................................................ 28
8.2 Hydraulics ......................................................................................................................................... 29
8.2.1 Special Safety Instructions ........................................................................................................ 29
8.2.2 Connecting the hydraulic lines .................................................................................................. 29
8.3 PTO shaft ......................................................................................................................................... 31
8.3.1 Special Safety Instructions ........................................................................................................ 31
8.3.2 Install the PTO shaft.................................................................................................................. 32
8.4 Intermediate PTO shaft .................................................................................................................... 32
8.5 Swivelling parking support into transport position ............................................................................ 33
8.5.1 Four supports (optional) ............................................................................................................ 33
9 Driving and Transport .......................................................................................................................... 34
9.1 Switching from working position to transport position ...................................................................... 34
10 Operation ............................................................................................................................................... 35
10.1 Before mowing ................................................................................................................................. 35
10.2 Mowing ............................................................................................................................................. 35
10.2.1 Folding down the Safety Device ............................................................................................... 36
10.2.2 Adjusting the lateral suspension arm ........................................................................................ 37
10.3 Folding Down Mowing Unit .............................................................................................................. 38
10.3.1 From Transport Position to Headland Position ......................................................................... 38
10.3.2 Headland Position ..................................................................................................................... 38
10.3.3 From Headland Position to Transport Position ......................................................................... 38
10.4 Swivelling parking support into transport position ............................................................................ 39
10.4.1 Four supports (optional) ............................................................................................................ 39
10.5 Detaching the machine .................................................................................................................... 40
10.5.1 Four supports (optional) ............................................................................................................ 42
11 Settings ................................................................................................................................................. 43
11.1 Adjusting the cutting height .............................................................................................................. 43
11.2 Adjust Locking .................................................................................................................................. 44
11.3 Adjusting the Compensation Springs ............................................................................................... 45
11.4 Hydraulic spring compensation (optional) ........................................................................................ 46
11.5 Setting of the pole protection mechanism ........................................................................................ 47
12 Maintenance .......................................................................................................................................... 48
12.1 Special Safety Instructions ............................................................................................................... 48
12.1.1 Test run ..................................................................................................................................... 48
12.2 Spare Parts ...................................................................................................................................... 48
12.3 Maintenance table ............................................................................................................................ 49
12.4 Tightening torques ............................................................................................................................ 50
12.4.1 Metric Thread Screws with Control Thread .............................................................................. 50
12.4.2 Metric Thread Screws with Fine Thread ................................................................................... 51
12.4.3 Metric Thread Screws with Countersunk Head and Hexagonal Socket ................................... 51
12.4.4 Deviating Torque ....................................................................................................................... 51
12.5 Rotary hub with shear fuse (optional) .............................................................................................. 52
12.5.1 After Shearing Off ..................................................................................................................... 54
13 Maintenance - Gearbox ........................................................................................................................ 56
13.1 Main gearbox .................................................................................................................................... 56
13.2 Mower Drive Gearbox ...................................................................................................................... 58
13.3 Oil level check and oil change on the cutter bar .............................................................................. 59

Krone EasyCut R 360 Specifications

General

Brand	Krone
Model	EasyCut R 360
Category	Lawn Mower
Language	English