Krone Swadro TC 680 - Tyres; Checking and Maintaining Tyres

Maintenance
107
Pos: 40.18 /Übersc hriften/Überschri ften 2/P-T/RReifen @ 0\mo d_1197357995667_78.doc x @ 18075 @ 2 @ 1
12.5 Tyres
Pos: 40.19 /BA/Sic herheit/7. Gefahrenhin weise alt/War nung - Falsche Reifenmontage @ 0\ mod_1197358162433_78. docx @ 18132 @ @ 1
Warning! - Tyre fitting incorrect
Effect: Injuries or damage to the machine
• Fitting tyres requires sufficient knowledge and the availability of proper tools!
• If tyres are not correctly fitted, it could explode when pumped up. This can cause serious
injury. If you do not have sufficient experience of fitting tyres, have tyres fitted by the
KRONE dealer or a qualified tyre specialist.
• When fitting tyres on the wheel rims, the maximum pressure given by the tyre manufacturer
must not be exceeded. The tyre or even the wheel rim could explode and/or burst.
• If the tyre heels do not fit properly when the maximum permitted pressure is reached, let
out the air, align tyres, lubricate the tyre heels and pump up the tyre again.
• Detailed information about how to fit tyres onto agricultural machinery can be obtained from
the tyre manufacturers.
Pos: 40.20 /Übersc hriften/Überschri ften 3/P-T/RReifen prüf en und pflegen @ 0\mod_1197358 037214_78.doc x @ 18094 @ 3 @ 1
12.5.1 Checking and maintaining tyres
Pos: 40.21 /BA/W artung/Reifen/Reihenfo lge Bild 6-Loch @ 4\mod_12130 86131413_78.doc x @ 86197 @ @ 1
1
KS-0-034
6
2
4
5
3
Fig. 69
Pos: 40.22 /BA/W artung/Reifen/Reifen pr üfen und pflegen nach War tungstabelle @ 134\mod_1350 480797454_78.doc x @ 1187905 @ @ 1
When loosening and tightening the wheel nuts, observe the order indicated in the illustration.
Check the wheel nuts: According to the maintenance table
Check the tyre air pressure: According to the maintenance table
Pos: 40.23 /BA/W artung/Reifen/Anziehdre hmoment @ 0\mod_1199955 905460_78.docx @ 37340 @ @ 1
Tightening Torque
Threading
Key size in
mm
Number of bolts
per hub - pieces
Max. tightening torque
black galvan.
M12 x 1.5 19 4/5 95 Nm 95 Nm
M14 x 1.5 22 5 125 Nm 125 Nm
M18 x 1.5 24 6 290 Nm 320 Nm
M20 x 1.5 27 8 380 Nm 420 Nm
M20 x 1,5 30 8 380 Nm 420 Nm
M22 x 1.5 32 8/10 510 Nm 560 Nm
M22 x 2 32 10 460 Nm 505 Nm
Pos: 40.24 /Layout Module /---------------Seitenumbruch---------------- @ 0\mod_1196175311226_0. docx @ 4165 @ @ 1