Krone Swadro TC 680 - For Design with Hydraulic Single-Rotor Lifting Mechanism

To Next Page

To Previous Page

Operation

Pos: 32.15 /Übersc hriften/Überschri ften 3/A-E/B/Bei Ausf ührung mit hydraulisc her Einkreiselaushebung @ 77\mod_13100504594 78_78.docx @ 667495 @ 3 @ 1

9.2.2 For design with hydraulic single-rotor lifting mechanism

Pos: 32.16 /BA/Bedienun g /Schwader/Krei selarme senken/heben/ Kreiselarme senken hy draulische Einkreise laushebung SW TC 680_760 @ 214\mod_1390381679853_7 8.docx @ 1755064 @ @ 1

SW700066_1

Fig. 34

• Insert the hydraulic control unit (4) into the bracket in the tractor cabin.

• Switch the switching valve (3) to the central position (II).

• Switch on the tractor.

• To relieve the locks (1), actuate the single-action control unit at the tractor and pressurise

the hydraulic cylinders.

• To release the locks (1), pull the actuating rope (2) and keep it tensioned.

• Set the single-action control unit (red 1+) of the tractor to the float position.

• When the rotors are in the working position, release the actuating rope (2).

• Switch off the tractor and secure it against the possibility of rolling back.

Pos: 32.17 /Layout Module /---------------Seitenumbruch---------------- @ 0\mod_1196175311226_0. docx @ 4165 @ @ 1