Krone Swadro TC 680 - Rotor Speed and Spreading Angle

Settings
97
Pos: 36.14 /Übersc hriften/Überschri ften 2/A-E/D/Dr ehzahl des Zusatzkreisels ei nstellen @ 167\mod_13678 21969619_78.doc x @ 1448075 @ 2 @ 1
11.4 Setting the Speed of the Additional Rotor
Pos: 36.15 /Übersc hriften/Zwischenüber schriften/A-E/ Bei Ausführung "Zusatzkr eisel" @ 504\mod_1498 545699491_78.docx @ 347 2908 @ @ 1
For version with “additional rotor”
Pos: 36.16.1 /BA/Ei nstellungen/Schwader Dreiwege-Stromrege lventil Bild SW 800/ 26 Zusatzkreisel @ 427\ mod_1455093084119_78. docx @ 2960445 @ @ 1
SW700107_1
1
2
3
Fig. 64
Pos: 36.16.2 /BA/Ei nstellungen/Schwader /Dreiwege-Stro mregelventil allgem einer Text SW 800/26 Zusatzkr eisel @ 428\mod_1455098 717747_78.docx @ 296113 1 @ @ 1
The rotational speed of the additional rotor can be set via three-way flow control valve (1).
Readjustment via three-way flow control valve may be necessary due to different tractor types
and oil pressures.
You can find numbers on the setting screw (3) of the three-way flow control valve.
If 0 is set next to the marking (4), the rotor does not rotate.
The higher the number next to the marking, the faster the rotor rotates.
Number 8 is set at the factory.
Pos: 36.16.3 /BA/Ei nstellungen/Schwader /Dreiwege-Stro mregelventil Text SW 800/26 Zusatzkreisel @ 167\ mod_1367823535837_78. docx @ 1448248 @ @ 1
• Select a greater number to increase the speed of the additional rotor.
• Select a lower number to reduce the speed of the additional rotor.
Pos: 36.17 /Layout Module /---------------Seitenumbruch---------------- @ 0\mod_1196175311226_0. docx @ 4165 @ @ 1