Krone Swadro TC 680 - Basic Setting of Rotor Inclination

Commissioning
53
Pos: 28.34 /Übersc hriften/Überschri ften 2/K-O/K/Kreisel neigung - Grundeinste llung @ 360\mod_1439286492 192_78.docx @ 2664217 @ 2 @ 1
7.7 Basic Setting of Rotor Inclination
Pos: 28.35 /BA/Er stinbetriebnahme/Sch wader/Kreiselneigu ng einstellen - Grundein stellung TC 680_760_B ild @ 360\mod_14393701562 48_78.docx @ 2666298 @ @ 1
TC680-002
X
1
2
1
X
2
X
3
X
1
X
3
X
2
Fig. 23
Pos: 28.36 /BA/Er stinbetriebnahme/Sch wader/Kreiselneigu ng - Grundeinstellun g TC 680-760_TS 620-740_ Text @ 365\mod_1441010808 345_78.docx @ 2685796 @ @ 1
• The rotor rake must be put down on level and firm ground.
• Move rotor rake into working position. In doing so, make sure that the running direction of
the guide wheels shows in the direction of travel.
• If necessary, drive up until the running direction of the guide wheels shows in the direction
of travel.
The rotor inclination is set via guide wheels on the chassis individually for each rotor. When
performing basic setting of rotor inclination, the tines (2) must have a certain distance X to the
ground (1). The following distances must be met when performing basic setting of rotor
inclination:
Distance
X
1
15 mm
X
2
5 mm
X
3
0 mm
Pos: 29 /Layout Module /---------------Seitenumbruch---------------- @ 0\mod_1196175311226_0.docx @ 4165 @ @ 1