Krone Swadro TC 680 - For Design with Collapsible Tine Arm; Move the Hoop Guards to the Working Position

Operation
68
Pos: 32.27 /Übersc hriften/Überschri ften 3/A-E/B/Bei Ausf ührung Zinkenarm klappbar @ 77\mod_1310050676669_7 8.docx @ 667550 @ 3 @ 1
9.3.1 For design with collapsible tine arm
Pos: 32.28 /BA/Bedienun g /Schwader/Zinke n / ZinkenarmeZinkenar me in die Arbeitsstellu ng schwenken @ 493\mod_14878 63297511_78.doc x @ 3318514 @ @ 1
3
2
1
2
1
SW9070017
Fig. 37
NOTICE! Swivel folding tine arms into working position in a certain order:
- In direction of travel right, swivel the folding tine arms into working position starting from the
rear.
- In direction of travel left, swivel the folding tine arms into working position starting from the
front.
• Pull the linch pin (1).
• Pull out the bolt (2).
CAUTION! When swivelling the tine arms into working position, turn the rotors so that the tine
arms do not collide with the guard.
• Swivel the tine arm (3) into working position.
NOTICE! The bolts may collide with the rotor axle if they are not inserted from above and
secured.
• Insert the bolt (2) from above.
• Secure the bolt with the linch pin (1).
Make sure that the linch pin (1) engages properly (the ring of the linch pin must be in the groove
of the shaft).
Pos: 32.29 /Übersc hriften/Überschri ften 2/P-T/SSchutzbüge l in Arbeitsstellung br ingen @ 2\mod_12029722 31499_78.docx @ 63393 @ 2 @ 1
9.4 Move the hoop guards to the working position.
Pos: 32.30 /BA/Sic herheit/7. Gefahrenhin weise alt/WARNUNG - Quetschgefahr @ 2\mod_120297199934 3_78.docx @ 63374 @ @ 1
Warning - Crush hazard!
Effect: Injury to hands
Do not hold onto hoop guards to swivel within range of the rotating points.
Pos: 32.31 /BA/Bedienun g /Schwader/Schutz bügel/Schutzbüge l in Arbeitsstellung bri ngen Bild SW TC 680_760 @ 213\mo d_1389957893594_7 8.docx @ 1748407 @ @ 1
SW700068_1
1
2
Fig. 38
Pos: 32.32 /BA/Bedienun g /Schwader/Schutz bügel/Schutzbüge l in Arbeitsstellung bri ngen Text SW700#_800#_900 # @ 133\mod_135003 3039848_78.doc x @ 1180812 @ @ 1
• Swivel the hoop guard (1) to the outside into working position and allow the locking (2) to
lock in place.
Pos: 32.33 /Layout Module /---------------Seitenumbruch---------------- @ 0\mod_1196175311226_0. docx @ 4165 @ @ 1