Safety
24
Pos: 16.11.1 /Überschr iften/Überschr iften 2/P-T/SSicher heitsroutinen @ 187\mo d_1380089318480_78. docx @ 1608182 @ 2 @ 1
3.5 Safety routines
Pos: 16.11.2 /Überschr iften/Überschr iften 3/K-O/MMaschi ne stillsetzen und sic hern @ 190\mod_1381323544 614_78.docx @ 1624780 @ 3 @ 1
3.5.1 Stopping and securing the machine
Pos: 16.11.3 /BA/Si cherheit/3. Sic herheitsroutinenMaschi ne stillsetzen und sic hern - mit und ohne Unterleg keilen und ohne Feststel lbremse @ 488\mod_1483427 611768_78.doc x @ 3283255 @ @ 1
WARNING!
Crushing hazard due to movement of the machine or machine parts
If the machine has not been shut down, the machine or machine parts may move
unintentionally. People may be seriously injured or killed as a result.
• Before leaving the tractor cabin: Shut down and safeguard the machine.
To shut down and safeguard the machine:
• Park the machine on a stable, horizontal and even surface.
• Switch off the drives and wait until coasting parts have come to a standstill.
• Switch off tractor engine, remove the ignition key and take it with you.
• Secure the tractor against the possibility of rolling back.
Pos: 16.11.4 /Überschr iften/Überschr iften 3/A-E/A/Angehobe ne Maschine und Maschine nteile sicher unterba uen @ 190\mod_1381323662 799_78.docx @ 162480 9 @ 3 @ 1
3.5.2 Supporting lifted machine and machine parts securely
Pos: 16.11.5 /BA/Si cherheit/3. Sic herheitsroutinen/Angeh obene Maschine und Maschi nenteile sicher unter bauen_ALTE FORM @ 277\mod_140 4810762702_78.doc x @ 2077603 @ @ 1
WARNING!
Risk of injury due to movement of the machine or machine parts
If the machine is not supported securely, the machine or machine parts may roll, fall or drop.
As a result, people may be seriously injured or killed.
• Before working on or under raised components: Securely support machine or machine
parts.
To securely support the machine or machine parts:
• Shut down and safeguard the machine, see chapter Safety, "Shutting down and
safeguarding the machine".
• Before performing any work on or under raised machine parts, lower the machine parts or
secure them mechanically with rigid safety supports (e.g. support stand, crane) or with a
hydraulic shut-off device (e.g. stop cock) to prevent them from dropping.
• Never support the machine or machine parts with materials which can buckle.
• Never support the machine or machine parts with hollow blocks or bricks. Hollow blocks or
bricks may break under continuous load.
• Never work under the machine or machine parts which are held up by a car jack.
Pos: 16.11.6 /Layout Module /---------------Seitenumbruch---------------- @ 0\mod_1196175311226_0.d ocx @ 4165 @ @ 1
To Next Page
Loading...
